How does the chicken manure belt welded by ultrasonics to be stronger and extend its service life?

Nowadays, ultrasonic spot welding machines are widely used in the welding of manure belts in chicken farms, but many users don't know how to use them when they buy it, or the belts are often broken, and some users do not know how to choose a suitable ultrasonic hand welding machine. .

Most users choose low-power handheld ultrasonic welding machine. The power determines the welding speed. The higher of the power, the better of the welding effect and the stronger of the welding. The higher the power, the shorter the welding time, and the Firm, low-power equipment can also achieve the welding effect, but it is a bit more difficult for novices.

In addition to selecting the right equipment, it is also important to master the welding method: the welding head must be perpendicular to the welding surface, press down the handle strongly when welding, do not remove the handle immediately after the welding is completed, stay for 1-2 seconds, wait for the weld It can only be removed after cooling and forming. If the handle is removed too early, the two PP boards may be deformed after being heated or wire drawing may appear at the welding point, which will affect the firmness of the welding point and the appearance. The pressure of the handle should be controlled when welding, too large or small will affect the welding effect. If the force is too large, the PP board may be welded through. If the welding is too small, the welding will not be in place and it will not be strong enough. After welding one point and welding the second point, it is necessary to ensure that each welding point is perfectly welded together.

The last is the number of welding points, which depends on usual experience. The spacing between the welding points of each row is about 4-6 cm in capital letters. The welding points of each row are best to be staggered, so as to ensure that each welding point will be affected during use. To achieve the equal distribution of the welding point, it has ensured that there is enough pulling force, and there will be no breakage.